Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am in a new network that has AP switch port configured as Trunk ports with the native vlan tagged. I have always read to have them set as access port with the vlan set. Is there any benefit to either of these options. I do like looking in switches ...
I am running a Cisco 5508 Wireless Controller with Software Version 8.5.151.0. The goal is to have Netflow monitoring client usage to identify clients using to much traffic and where the total over all traffic is going or coming from. I am running...
I am wanting to give a group of IPADDRs there own Public IPADDRs. I have around 75 /26 address that are in every sites scope that I will need to set this for. Typically I place the guest traffic on their own /16 subnet and create on object network GU...
Is there away to pull the object network name with both the host or subnet and nat configuration? Currently I am having to do a show run and copy the object with object-groups section along with the NAT sections, paste them into Sublime Text 3 and se...
I have a stack of 3850, currently there are 3 in this stack. I would like to place a Loopback IPADDR on each of the switches in case one would drop. I currently am monitoring the main management IPADDR but when the 3 switch decided to drop a couple t...
Currently the AP gets its IPADDR from being in switchport trunk native vlan 800. I dont see the point having a truck connection since the AP is just passing traffic to the controller, but for FlexConnect, I can understand.
Each site will be using 1 Public IPADDR allocated for Guest that will be seen on the internet. I would like to move the Guest traffic to its own because in the past I had a Guest user get the Public IPADDR Blacklisted. It was tired to the production ...
