02-11-2020 06:25 AM - edited 07-05-2021 11:41 AM
I am in a new network that has AP switch port configured as Trunk ports with the native vlan tagged. I have always read to have them set as access port with the vlan set. Is there any benefit to either of these options. I do like looking in switches and seeing the vlan in the show interface status.
02-11-2020 07:04 AM
02-12-2020 06:33 AM
02-12-2020 11:34 AM
Currently the AP gets its IPADDR from being in switchport trunk native vlan 800. I dont see the point having a truck connection since the AP is just passing traffic to the controller, but for FlexConnect, I can understand.
02-13-2020 08:02 AM
01-09-2024 06:14 PM
Good information
But suggest to configure
spanning-tree portfast trunk
stp bpdugard
the port will not go to the listening, learning states in case of a state change. This should not be configured on trunk ports connected to other Switches or STP enabled devices.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide