Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The RV345P only offers DH2 & DH5 for Diffie-Hellman. However, Cisco's own documentation states that DH 1, 2, & 5 should no longer be used. So, how about an improvement to the DH options?
In order for my VoIP to work, I have to have the SIP Gateway checked under the Firewall tab. However, if I make ANY change to the router's configuration, I then have problems with the phones. We can hear the person calling in, but they can't hear us....
I just upgraded 7 WAP571s to the new firmware from 1.0.2.6. While it works, I did notice some problems. I list them below. 1) Administration a) Time i) Set for UTC-06:00 USA (Central) ii) Current Time display shows 5 hours ahead (current U...
Actually, I would not configure Root Guard on Access ports. I would configure BPDU Guard on Access ports. This will prevent a rouge switch that attaches to those port from becoming root because BPDU guard will shut down the port. Root Guard should be...
It will depend on the specifications of the WAP. The SG300, if you have a model with PoE, has 802.3at PoE, also known as PoE+. If the WAP requires the new 802.3bt, then no, it won't be supported by the SG300. Read the specs of the WAP carefully. Some...
Ok, I've tried everything I can think of, including the Factory Reset on the 4 units and have had no luck. I've sent you a private message with the information you requested. Wayne
Borislav,I'll give it a try the next time I'm in the facility, probably Friday or Saturday. However, since all SEVEN of the units are having the NTP issue, I suspect it's more than that. The reset may help on the ones that aren't sharing their 2.4 GH...
So the question is, what's different about the Android devices? That's why I brought up that they are capable of augmenting the Wi-Fi with 4G. This could be bypassing what you've set. It's a setting in the Android device.On my device, the setting is ...
