Hi, I have a Cisco 7120 router with a 100Mb connection up and down.  I'd like to see if it's possible to find out how much of that I'm using.  I found a post online that said to set my interface to "load-internal 30" and then run  "show int fa0/0"   ...

Hi, I'm trying to figure out how to block ports and secure my older router that doesn't have SSL, crypto, ip inspect and I'm sure I'm missing a few other things. I added these to my my config file but I think it might have worked too well because my ...

I'm very new to Cisco routing.  I have a 7100 series router and a new ISP that will advertise our IP block. I'm trying to figure out how to configure the router to allow us to use the IPs from our block.  Any pointers on what I'm missing would be gre...