Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've looked everywhere and everyone talks about it as though I have access to this device. I do not and need to perform a hard factory reset. Any ideas?
So far I've held down the reset button for 30+ seconds while plugging in the power. I started to...
Hello. I have a cisco 9372PX and a 3750-x connected to each other.
I am getting native vlan mismatches in the logs on the 3750-x only and unsure why as i'm in the understanding that both switches can use their own native vlan.
9K Config
interface E...
My goal is to have an 891 router at a branch office with two, always active VPN tunnels where the routing would switch to the secondary tunnel within the 891. On the Hub side there would be two ISPs connected into the same MPLS cloud which has intern...
so since I already have vlan 190 specified for the allowed traffic, vlan 6 specified as the default native for the 9k, vlan 7 specified as the default native for the 3k. I should create a 4th vlan that both switches will use just for the native?
Is ...
Thank you.
Not sure what the :20 is in the AS number?
So my config would look more like this:
ip prefix-list xx-mpls-filter 10 permit 172.22.16.204 eq 32ip prefix-list xx-mpls-filter 5 deny 0.0.0.0 eq 0
router bgp xxxxneighbor x.x.x.x remote-as xx...
