Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have access to CLS SSNGFW course lab and was researching the FMC/FTD back up functions. But I read this from the docs and it confused me. Requirements for Backup and RestoreBackup and restore has the following requirements.Model Requirements: Back...
I stumbled across the add route feature for DMVPN load balancing with EIGRP but can't seem to get the hub to identify or advertise both routes to 10.1.146.0/24. The EIGRP topology database has 2 routes with the same feasible distance and composite ...
Cisco docs state IPv6 is disabled, but my 3850 running 16.3 is responding to the link local FE80:: packets and the SVI's have IPv6 neighbor discovery configured. See table 38-1 in the doc for 3850 IPv6 defaults.The docs also state: "The switch uses ...
Upon initiating the "software install flash:x new force" command to install the 385MB OS the switch tells me I need 395140KB of memeory but with dir flash: I see I have 910249984 bytes free. As you can see I have 2x the space needed. With install mo...
I'm using 6.6 and having this issue all of a sudden. I don't have any ACLs applied to the mgmt interface either. I have GUI access but not cli. It's not as simple as "enabling." The "disable" drop down does not have an "enable" option. I added t...
Are you saying that this nerd knob requires multiple tunnels to load balance traffic to 10.1.146.0 between R1 and R4? I don't read the solutions guide that way. Not sure it's best practice or common to have multiple dmvpn tunnels to the same NBMA ...
This boot sequence did not work for me. There are several docs out there with other methods that didn't work either. :/. Putting the old flash back in until we can figure out what the issue is. New flash stays in continuous boot that cannot be bro...
