Hello Everybody, I have a problem when I try to install ACS 4.2 on Server 2003 R2.When I start the ACS setup, i recive an error message saying: I searched a bit on the internet but didn't find any helpfull solution. Anybody has any idea how to fix t...
Hi all,I'm curently studying for my CCNP Switch certfification, and I'm learning about RADIUS and AAA. I need to practice this topics, but unfortunately I can't find any way to do it. I have cisco ACS 4.2 but I'm unable to install it on my Server 200...
Hello,I'm planning on installing a Cisco Unified Communications Manager as a subsequent node, and I'm wondering if the subsequent node needs it's own SIP trunk for outbound calls, or it uses the trunk from the primary node?Thanks,Maksim
I recently tried to configure IPv6 NAT-PT on my Cisco 1841 router, flashed with IOS version 12.4(25a). However when i go to config mode, I can't type the appropriate NAT-PT commands. For example:Interkonekciski(config)#ipv6 nat ?% Unrecognized comman...
Yes I rebooted and no use. I found the problem. It's because ACS 4.2 is not supported on Windows Server 2003 R2. I tried installing it on regular Windows Server 2003 (not R2), and it works.
Yes, Media Termination Point Required is checked on the trunkWhen I go to : Media resources and then to Media termination point there are 2 termination points. One on the publisher and one on the subscriber. The Cisco IP Voice Media Streaming App ser...
Thank you for the response Karthik.I have just another question. The subsequent node syncs with the publisher(primary node) and inherits the configuration. Then when we disconect the primary node, the sip trunk for outbound calls on the subsequent no...