Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are running on-premise CUCM 12.0.1.2290011 and trying to enable APNS for jabber clients. Following the instructions here: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/push_notifications/cucm_b_push-notifications-deployment-guide/cuc...
Looking for advice for managing our FirePower module integrated with an ASA 5516. Currently we manage it via the ASDM but I have been looking into using a FMC VM appliance. Does it make sense to use FMC since we only have 1 firewall/1 FirePower? L...
Receive the "call can not be completed as dialed..." message when dialing a particular number. The number is in the range 916-859-xxxx. We are able to successfully call other numbers in the 916 area code so I don't believe it's any kind of route pa...
We have a shared line on multiple phones. Most of the calls on this line are handled by one person. Caller #1 calls in and the call is answered here on phone #1. While on the call another call comes in on the line so Caller #1 is put on hold by th...
If someone is on-hold is there anyway they can dial 0 to get back to the operator (or somewhere else)? I am aware of the on-hold reversion setting that alerts you if you leave someone on hold too long but was wondering if the person on hold has anyw...
After speaking with TAC our current build is not supported for push notifications. Builds at 11.5.x and 12.5.x are so we are apparently in no-mans land and would need to upgrade or downgrade(?!) for this.
