Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can I control the bandwidth per client WLC 5520 8.5.161we have a 200mbps internet connection at the moment all the clients are receiving 150mbps + on speed test however at the moment we have very limited users but expecting to increase during a speci...
Hi GuysI have some indoor AP's configured and running on with my WLC 5520now I'm trying to configure my outdoor AP's to the same but it doesn't seem to work. WLC ver 8.5.161AP ver 8.5.140.0 im getting the following when i console to the AP CRIT-MeshL...
Hi Guys WLC 5520 x 2on SSO Configured and it's working I'm using LAG on both the WLC's the stand-by WLC port sometimes goes offline due to which the failover doesn't take place during this time. as per the documentation from cisco we cannot set LAG a...
HiI have a network with 5 access switches connected directly to a cisco 4500, also i have enabled intervlan routing globally so communication between different VLANS with different subnet is not an issue as im new to the subject just want to know ho...
Hi Scott,believe me, I hate limiting the bandwidth as well but I have been forced to do so to make things simpler I have set the data rate under WLAN>>SSID >>Qos>>Override Per-User Bandwidth Contracts (kbps) this seems to be working jamy66
Hi guys thanks for the support I was able to rectify this issue I wasn't aware that for outdoor type AP's I need to provide the MAC address of AP on the WLC for authenticationonce added the connection was made automatically. It would be nice if it is...
