Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have vmanage, vsmart and vbond set up on cisco cloud.
we have 1 vmanage, 2 vbond and 2 vsmart set as site id 200.
i had 2 left over vsmart to set up and i set them up as 300.
now i'm trying to change the site id where all of controllers has same ...
I'm trying to update software of vWLC (small scale version to 8.3.143.0)
Below is the current show sysinfo.
(Cisco Controller) >show sysinfo
Manufacturer's Name.............................. Cisco Systems Inc.Product Name............................
what does [None WPAv2 PSK] error message mean?
parent lost: received disassociate (1) failure
associated to AP_MAC and then [None WPAv2 PSK]
it repeats and repeats.
What could be the issue here?
I have configured 1602 as bridge and other APs are at local right now.
I have to change AP from local mode to bridge in order bridge AP to work, correct?
Below is the show logg from the AP
8 00:58:17.031: %DOT11-4-CANT_ASSOC: Interface Dot11Radio...
@Jurgens L @Haydn Andrews
This is the outcome of the message, i was able to get it associate, but i can't use internet off of AP.
show dot11 association.
*Sep 8 00:33:59.419: dot11_mgmt: bad cookie returned from driver for mac (expected 0x0, got ...
@Jurgens L
Existing Wireless Infra AP is currently set Local Mode
and 1602 is WGB right now.
if i convert 1600 AP to a lightweight image, it can be still managed by WLC?
AP on the left is an autonomous which is standalone AP and set as bridge (refer config), and AP on the right is connected to WLC and set as local mode
@Haydn Andrews
@Haydn Andrews
Do you mind reviewing the config? i've attached it.
I also attached image of what it looks like. AP on the right connected to WLC and on the left is what i'm trying to configure.
It's not associating.
Basically, left AP is configu...
