Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As shown below I have a network with two L3 switches CoreSW C6500 and S2 C3650, they form OSPFv3 adjacency over vlan 724. The following networks 192.168.60.0/24 and 172.24.0.0/24 are all part of area 0, on S2 172.24.x.0/24 are all part of area 24 exc...
HelloI am trying to configure an ISR 4331 with GLBP, but it gives an error, the config is: interface GigabitEthernet0/0/1.70encapsulation dot1Q 70ip address 10.1.70.1 255.255.255.0glbp 70 ip 10.1.70.254glbp 70 preemptglbp 70 authentication md5 key-ch...
Hi,
In a setup with a router 2901 and a L3 Switch C3750G (take a look at the image) both setup with OSPFv3 and assigned with both global unicast and link local addr. I can ping from the router to the switch and vice versa.
Debugging hello pack...
Hello,When the interface vlan 724 is shutdown on CoreSW the 172.24.0.0/24 network don't show up in the routing table, but still vlan 2 as a connected network, and on S2 there is only two connected networks the 172.24.0.0/24 and 192.168.2.0/24 in the ...
Hi Harold,
Here you have the requested output:
R1#sh ipv int g0/1GigabitEthernet0/1 is up, line protocol is up IPv6 is enabled, link-local address is FE80::1 No Virtual link-local address(es): Description: LAN Global unicast address(es): 2AY...
