Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Members, I have configured SNMP Protocol at Router1 and Router 2 ( Connected on Serial Interface). I am collecting data for my PRTG monitoring tool from SNMP trap config at R1 and R2. I would like to config now IP SLA and Netflow v9 or v5 at Cis...
HelloI have enabled STAC Compression on HDLC Serial Link. I choose 8192 Bytes ICMP to test the compression and got below results. I run it three times and got three different compression ratio . FIRST TIME :R2#ping 20.0.24.2 repeat 1 size 8192 timeou...
Hello, Can we apply Stacker/Predictor compression command in CISCO CLI using CISCO Packet Tracer ? I want to generate Traffic and apply compression command to evaluate. Please advise. Thanks Timmy Syed
Hello I have config it at Routers and but it show Grey at PRTG. I am figuring out the issue at PRTG. Meanwhile i have two question 1. Will NetFlow Provide me the delay and packet loss parameters ? or IP SLA is better ? 2. I have already configured SN...
Hi I haven't started as didn't get any clear details to config and linked it to PRTG. Can you help me please. Below is my network.PC1 --Fast Ethernet--- > Router 1(192.168.10.2) --Serial-- > Router 2 (192.168.10.4) --F.Ethernet-- > PC2 ( PRTG) Thanks
Thanks for the reply but i have not yet tried Predictor. May be the its due to ICMP Packets ? where we dont know the randomness of payload. May be give more stable result when actually traffic pass through ? Any update on my point 2 and Point 3 ? 2. ...
