Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there, I am running into some issues when trying to get clients connected to my RC340 router. I have followed the solution that is posted in this thread. https://community.cisco.com/t5/small-business-routers/how-to-connect-to-rv340-on-windows-v...
When applying set network gateway 10.0.161.223 to my installation of CUCM it begins to show on my network, but with an address that is outside of my IP range of 192.168.15.61. I applied the set network ip eth0 10.0.161.143 255.255.255.0 and get a res...
I have a Cisco 1921 I am wanting to use for internet connections at home. My internet service provided is spectrum and I have a modem I want to use for this. I would like to use G0/0 to go from the back of the modem, to the router. So this would be t...
I have added several ringtones to my server so that users will have more ringtones to choose from. While I was successful in getting them added to the server and getting them to show up and play. There is a pop noise at the beginning of each sample. ...
I have a cisco 8961 that has a bad firmware installation. I need to upgrade the firmware back to SCCP since it is on the SIP firmware at the moment. I do know that pressing the # key followed by the sequence 123456789*0# is how to do it on the 79XX s...
Thanks. I was not expecting this to be asking for the router passwords to sign in. Created a user account in Users and was then able to connect with that information.
Here is some screen shots of the config that I have running on my router. I do not understand why I am getting prompted with a credential prompt when trying to connect. I have tried BOTH the config in the thread above and the video that is on youtube...
Hi there thank you for showing me this video. I have also watched this video, and have tried the configuration that is shown in this video and the other thread on this topic. Both of these solutions results in it asking for credentials. I am not sure...
I now also have a new status message, 'The remote connection was denied because the user name and password combination you provided is not recognized or the selected authentication protocol is not permitted on the remote access server.' It might also...
This copy of CUCM came in a form of a VMware disk image, my ip subnet is10.0.161.100. The copy of CUCM came preconfigured with a 192 address, I amtrying to change it to an address that is in my subnet Here are the commands that fixed this issueset ne...
