Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I’m having a hard time getting the securityk9 license to “activate”. I was under the impression that if you purchased a new router with the securityk9 license it would be preinstalled. I used the command “license right-to-use move securityk9”That cha...
Hello all,My question is does the Cisco 3845 support ipsec because when I go to configure the IKE key exchange on the Cisco 3845 with the command "crypto isakmp policy 200", I don't have the option to choose isakmp. The crypto ? command shows that I ...
I'm trying to connect 3 routers.
R1-------r2-------r3
I want r2 to act as the Internet. What do I have to do for r1 and r3 to be able to ping each other if I have a network of 200.100.50.0 /30 between r1 and r2 and a network of 75.75.75.0 /30 betw...
Hello community,
I am running the Cisco Adaptive Security Appliance Software version 9.5 (1) and I want to allow RDP from any outside IP to an inside server. I got help last week opening some ports for software so I figured I could use the same meth...
Hello community,
I'm a Cisco novice that just attained his CCNA, however , I have no experience with the Cisco ASA appliances. I have all the basic stuff set up such as NAT, DHCP on the inside interface and things off that nature. The issue that I a...
Hello BB,Thanks for your reply. I just confirmed with our Cisco account executive that they sent us a router with the wrong license. Thanks for the speedy reply though.
This is the NAT config (by the way, this is new to me as I just received my CCNA but I've never worked with the ASAs)
object network obj-x.x.x.x X.X.X.X = Internal IP of server host X.X.X.X
object network INSIDE host X.X.X.X
object network ob...
I am running the Cisco Adaptive Security Appliance Software version 9.5 (1) and Device Manager version 7.5 (1). Thanks some much for your speedy reply.
