Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to set a simple GRE tunnel from a local router to a CISCO CSR at Amazon.
The CSR at Amazon is configured with two interfaces: outside and inside.
The outside interface gets a private IP, 10.6.0.226, via DHCP. There is a public IP associat...
We are having issues with wireless clients accessing wired Apple TV devices. Current environment:WISM2 installled in a Cat6807XL configured for VSS.Sup modules are Sup2TWLC running 8.0110Apple TVs are on wired networkWired VLANs are trunked to WLCWir...
We will be converting two 6500s to VSS. Each chassis has a Sup2T module, fwsm, 6908-10G blade, wism1 blades and two or three 6748-SFP blades. I was wondering how long the conversion process takes? If I remember correctly at the 2012 networkers lab i...
What should be the outcome of a "clear route" command on a fwsm that has EIGRP configured? Is this command equal to the "clear ip route" in IOS?We have two fwsm (separate chassis) configured in an active/standyby configuration. We somehow failed ove...
I have a fwsm running 4.0(5) stuck where I cannot access any of the files in the flash. This is a test module (for now) that was loaded with a bad configuration file. When I try to access the flash I get "Configuration update in progress by another ...
Mike,Thanks for the reply. What I am trying to discern is if the fwsm command "clear route" is as benign as I thought it was. Do the dynamically learned routes just get relearned? Does EIGRP reconverge?For some reason, out fwsm failed over to the st...
OK, this time I will include some text. We are looking into the possibility of running LMS 2.2 and RTM 1.4 on the same server. Is anyone doing this and if so, any recommdations on hardware (memory, disk space, processors). Or, is this really a ba...
Have you tried installing IDU 2.0 for RME 3.4?I was having some weird problems with our 2950s and RME. Device attributes for the 2950s would say TACACS not supported. I installed the IDU and my problem cleared up.
You can use the port security feature. Set the max mac address for the port to 2. The first two mac addresses it learns will be the only ones that can access that interface. The port can be set to shutdown or deny access upon a violoation. If the...
