Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having a problem trying to get to my root view. I am trying to set up some views to allow restricted access to one of our routers.When I try to go to the root view, I get the following>enable viewPassword:% Authentication failedI have used the ...
I have a strange problem with HSRP running on two Catalyst 4506'sThe set up is as follows:Two 4506's connected by an Etherchannel are hosting VLAN interfaces for all our VLAN'sEach VLAN has an interface on each 4506These interfaces are paired togethe...
Hi,I have a problem with a VPN tunnel on a 1841 seriesThe router has four tunnels, all of which show as UP with sh crypto sessions. I can ping down three of the tunnels but not the fourth. This router has an almost identical config to a number of oth...
Hi,I have a problem with a 1841 router at one of our remote sites.The hardware is as below:Cisco 1841 (revision 6.0) with 237568K/24576K bytes of memory.Processor board ID FCZ104211TW2 FastEthernet interfaces2 Virtual Private Network (VPN) ModulesDRA...
This problem has now been resolved by powering off both the core switches and then powering on Switch1 first, allowing it to come up completely, then bringing up Switch2. When this was done everthing started working correctly.Thanks for all the sugge...
Dear AnserThanks for the suggestions. All the VLANS use different HSRP numbers and I have checked for IP address conflicts.I have run debug on both switches and enclose the output as well as other output requested. From the debug it looks like switch...
Jon,All the other VLANs are working and have their timers set to 10 30 on both interfaces. I assume this is because they can see each other.I beleive I did do a shut/no shut but you have now sown a seed of doubt. I will try this later today when I ca...
