Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have two Nexus 5548 in a dual HA configuration. We have HSRP configured on VLAN705 on both Nexus and the VIP is xx.1. The access switch is a WS-C3560X-48P, the log on the Nexus is filled with duplicate IP address messages for the HSRP VIP address...
We have a WS-3560 switch running IOS c3560-ipbasek9-mz.122-50.SE3.bin, this switch is an access switch user are getting drop off network when using IE, Outlook and web app's. When we check the interface counter error we see the output below, out disc...
Hello All, I have to reload 5 switches tonight the units are WS-C2960G-24TC-L known as LANBASE switches. My question is I have always been taught the config-reg should be 0x2102, but on these switches is is 0xF, does anyone know why Cisco has changed...
Hi Guys, I am working on pushing a config job through Cisco Works to 600 routers and switches. I need to create a script for exec-timeout for 20 minutes. My question is, I see the command is exec timeout 0 0, the first 0 is seconds so for twenty minu...
We have a large enterprise network and our routers and switches are running HRSP. We were told the preempt command should be added to the interface of both the primary and the standby router. We have checked our configuration and notice that the pree...
Hi,Can the Juniper switch port be set to channel-group mode active? Active - Active should form a etherchannel. You have no port lights, have you tried bouncing the port channel interface? You might try using the channel-protocol command it just enab...
Hi , I had similar problems with Cisco Work discovering switches in Panama, I was able to fix it by checking and changing the discovery settings. I change the HOP limit and confrim that all of our subnets were listed in the Filter Settings, is the un...
I would suggest Auto QOS it is easy and I have used it on my switch port, you can set ip up to trust VoIP or use a basic auto qos trust. look through the doc's below. HTHhttp://www.cisco.com/en/US/docs/switches/lan/catalyst3550/software/release/12.2_...
I read your posting and the ingored errors are usually caused when aport has low or no buffer space available, the packets are not processes and when buffer space is available they should be resent. causes high CPU or LAN broadcast. Have a look at th...
