Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Does anyone know where I can find the NTP configuration guide for IOS 12.4T ?I think it used to be here..http://www.cisco.com/en/US/docs/ios/netmgmt/configuration/guide/nm_basic_sys_manage_ps6441_TSD_Products_Configuration_Guide_Chapter.htmlTh...
Hello all, I would like to confirm the behaviour of using multiple statements of the 'set-peer' command under a single crypto-map sequence for IPSEC tunnel failover. In particular, what happens when a peer that was previously unavailable comes back t...
Hi All,I would like to understand how to calculate the multilink ppp fragment delay setting. Is there a formula to calculate this?For Example: I would like anything over 60 bytes fragmented. How can the fragment delay (or any other command) be used t...
Hi All,I'm doing some testing in the Lab and have 3 x 3750's daisy chained together running VTP, with 802.1q trunks hardcoded.SW1 <--> SW2 <--> SW3SW1 and SW3 are in VTPv1 domain A and are both in 'Server Mode'. However, SW2 is in VTPv2 domain B and ...
Hi All,Can someone please explain how the 'byte-count' values are calculated for Custom Queuing, particularly when assigning a certain percentage to say three different queues for protocols with various packet size.For example:I would like to allocat...
Hi Lei,I've been doing some further testing on this topology and have found that using HSRP to engineer traffic to use the primary path works when there is a single failure (i.e Router D alone shuts down then recovers or Router A shuts/recovers). How...
Lei,Yes, that is correct. Router C becomes the HSRP primary when Router D is down (or when Router D's WAN link goes down). When Router D comes back up, Router D becomes the active HSRP and Router C is standby.Thanks.
Hi Lei,Here is the output:Router D is down:RouterA#show crypto sessionCrypto session current statusInterface: FastEthernet0/0Session status: UP-IDLEPeer: 10.2.1.58 port 500 IKE SA: local 10.2.36.178/500 remote 10.2.1.58/500 Active IPSEC FLOW: permi...
