About layer3

layer3 · 04-06-2011

Hi all,Does anyone know where I can find the NTP configuration guide for IOS 12.4T ?I think it used to be here..http://www.cisco.com/en/US/docs/ios/netmgmt/configuration/guide/nm_basic_sys_manage_ps6441_TSD_Products_Configuration_Guide_Chapter.htmlTh...

layer3 · 09-14-2010

Hello all, I would like to confirm the behaviour of using multiple statements of the 'set-peer' command under a single crypto-map sequence for IPSEC tunnel failover. In particular, what happens when a peer that was previously unavailable comes back t...

layer3 · 05-29-2008

Hi All,I would like to understand how to calculate the multilink ppp fragment delay setting. Is there a formula to calculate this?For Example: I would like anything over 60 bytes fragmented. How can the fragment delay (or any other command) be used t...

layer3 · 05-26-2008

Hi All,I'm doing some testing in the Lab and have 3 x 3750's daisy chained together running VTP, with 802.1q trunks hardcoded.SW1 <--> SW2 <--> SW3SW1 and SW3 are in VTPv1 domain A and are both in 'Server Mode'. However, SW2 is in VTPv2 domain B and ...

layer3 · 05-26-2008

Hi All,Can someone please explain how the 'byte-count' values are calculated for Custom Queuing, particularly when assigning a certain percentage to say three different queues for protocols with various packet size.For example:I would like to allocat...

layer3 · 04-06-2011

Thanks for the reply Naidu.But I'm specifically after the location of the 12.4T IOS NTP configuration guide.

layer3 · 09-18-2010

Hi Lei,I've been doing some further testing on this topology and have found that using HSRP to engineer traffic to use the primary path works when there is a single failure (i.e Router D alone shuts down then recovers or Router A shuts/recovers). How...

layer3 · 09-15-2010

Hi Lei,Thanks for helping clarify this behavior. Much appreciated.

layer3 · 09-15-2010

Lei,Yes, that is correct. Router C becomes the HSRP primary when Router D is down (or when Router D's WAN link goes down). When Router D comes back up, Router D becomes the active HSRP and Router C is standby.Thanks.

layer3 · 09-15-2010

Hi Lei,Here is the output:Router D is down:RouterA#show crypto sessionCrypto session current statusInterface: FastEthernet0/0Session status: UP-IDLEPeer: 10.2.1.58 port 500 IKE SA: local 10.2.36.178/500 remote 10.2.1.58/500 Active IPSEC FLOW: permi...

Member Since	‎12-07-2006 06:05 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	24

User Statistics

User Activity

NTP configuration guide - 12.4T

Multiple set-peer statements - failover behaviour

Multilink PPP fragment delay command

VTPv2 Transparent Mode - Not forwarding VTP packets in different Domain

Custom Queuing - How to calculate 'byte-count'

Re: NTP configuration guide - 12.4T

Re: Multiple set-peer statements - failover behaviour

Re: Multiple set-peer statements - failover behaviour

Re: Multiple set-peer statements - failover behaviour

Re: Multiple set-peer statements - failover behaviour