Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I have searched information , but i did not found anything. I need to identify the vendor of my routers on my ISE deployment to apply diferents tacacs commands sets and policys. I have Cisco and Huawei. Anyboyd knows a guide or info to do th...
Hello Iam using DNAC 1.3.3.7 and i have create a Network settings with SNMP , netflow colectors and syslog,etc .. But when i applied the network profile, in the Telemetry secction show the following error:No non-eta enabled access switchports with d...
Hello guysI have tried to integrate Cisco ISE 2.2.0.470, with an working Active directory, but show the following error message. I have checked several times the configuration but the problem persists. I have run the Test and none had failed.Any ide...
Hello teamI wonder how to get trought CLI Serial numbers of inserted SFPs 10Gbit port of DNAC. I hace tried:sudo lshwsudo cat /sys/devices/virtual/dmi/id/chassis_serialBut i cant get the info. any suggestion ? Thanks! Cheers
HelloI have a Cisco 887G-K9 with version 15.1-4 3G router, I set up the router following the guidelines of cisco, but i cant stablish a succesfull connections, the router have the interface cellular 0 up with good RSSI, but when i force traffic to i...
True, i have solved my problem "tricking" with the auth policies. Creating one profile for both vendors Cisco and Huawei, including both tacacs+ commands sets. thanks por support!
@Marvin Rhoads Thanks!! Yes i have already created as you described, But i dont need separate device per IP address. Because i only have one loopbak IP range with cisco and huawei mixed ... This is the problem.So I need that ISE detect the vendor w...
Hello Balaji Tahnks but This is not that i am looking for. I am looking to apply diferent tacacs command set, if the device is huawei or cisco.I have read thishttps://www.cisco.com/c/en/us/td/docs/security/ise/2-1/admin_guide/b_ise_admin_guide_21/b_i...
I had already read that guide, but nothing comes there.ThanksMaybe the Assurance guide have a tip -"Resynchronize the network device to read this interface description. The Network Telemetry tool looks for interfaces with the word lan in the descrip...
Yes you are right. the Disk is full . i saw this message when i tried to access throught CLI "unable to launch ade-os shell. disk full" Open a case is neede to solve this problem. Thanks all for ur support!
