Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have some weird behavior. My Cisco Catalyst 9200 switch reacts slowly on whichever command i type in configuration mode, while in exec and enabled mode it reacts at normal speed.It is the same behavior in on SSH as on Serial. 2 days ago I did confi...
I finally found a function for the compliance tool and wanted to use it. I experimented with it earlier this year on a PI 3.4 installation. But considered it hard and stiff to use, and didn't get the expected results. Sinds that time I installed a ne...
Currently I have the problem that Cisco Prime infrastructure sometimes gives the error "SNMPReachability Status is Unreachable" for a switch while this is not the case. It happens always for the same 3 switches. (we have more that 300 switches where ...
Hi All, Today I encountered weird behavior on my switch when i configured through an interface template.To my knowledge Spanning-tree portfast should be configured on the interface itself, and won't work when it is only present in the template. There...
I am planning to upgrade our network security by deploying TACAC login on the switches.We already setup an AD group and Cisco ISE server and are able to log into the switches with specific AD users.There is an Cisco Prime server which will get his ow...
Ok, tried one last thing, and it apparently worked. We use Cisco ISE login on the switches and I did not yet added this new switch to ISE. Apparently the switch configuration mode get slowed down when the ISE server is ignoring the switch. Enabled m...
Update:Reboot didn't work either. I tried to compare credential verification traffic (with tcpdump on the prime server) with another switch of the same model, version and location but couldn't see any problems. show tech doesn't show anything either....
I installed prime with express plus configuration because it didn't use more CPU/RAM than that. kinda bad from cisco that it doesn't make it possible to re-enable the compliance tool when switched to the standard/professional configuration without a...
Ok, I was to hasty. deleting finally worked. Only took half a day to be processed But it did not solve the SNMP problem. My next step is rebooting the switches itself. This will take some time because production. But keep you informed.
