About kkct

kkct · 09-19-2019

Okay, I'm a newbie. My question: I have set up 2 routers, connected to each other: R1int s0/3/0ip address 192.168.1.1 255.255.255.252int lo0ip address 1.1.1.1 255.255.255.0 R2int s0/3/0ip address 192.168.1.2 255.255.255.252int lo0ip address 1.1.1.2 2...

kkct · 06-05-2019

Hi, I want to begin my study with a home lab. I bought several second-hand Cisco switches and routers. I haven't tested them yet. 1. I've heard that I need to have drivers installed. I searched the web and it seems that the only way to download dri...

kkct · 05-26-2019

Hi, I'm a newbie and still struggling with vlans. I have a topology shown in the diagram. I want to assign PC0 and PC1 to two different vlans, and I want both PCs to have internet connection. Is it possible? If yes, what should be the gateway ip addr...

kkct · 05-22-2019

Okay, I'm a newbie and hope this question won't sound stupid to you guys. I've a topology shown in the figure. I use ROAS on the left hand side, and obviously I can't ping the right hand side from the left hand side. Is it possible for both sides to ...

kkct · 05-21-2019

Hi, I'm new, configuring a basic ROAS with 2 PCs, 1 switch and 1 router using Packet tracer, I can't ping from one PC to another PC, here is my configuration: 1. PC1 configuration (in vlan 10):ip address: 192.168.1.1 255.255.255.0 2. PC2 configuratio...

kkct · 05-27-2019

Thank you so much! I don't know that NAT can be used in this way as it is not mentioned in the textbook

kkct · 05-22-2019

Thank you very much!

Member Since	‎04-25-2019 12:30 AM
Date Last Visited	‎11-05-2019 11:16 PM
Posts	7

User Statistics

User Activity

Loopback interface

Setting up a home lab

Can two vlans go through the same router to the Internet?

How to route beyond ROAS?

Can't ping using ROAS in Packet Tracer

Re: Can two vlans go through the same router to the Internet?

Re: Can't ping using ROAS in Packet Tracer