Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Afternoon All,I am currently working on a Site-2-Site VPN at home I have connected a cable between both Outside Interfaces. It's been a while since I have done this on an ASA5505. I have this little voice telling me there is an issue with the differe...
HiI have configured the interfaces on a switch with a failed authorize for it to go into a blackhole vlan 999see config below however it's still connecting to our domain even though the machine only has a local account setup I am wondering if there i...
HiI have one node with 2 interfaces that are bonded on a server (LACP) and share the same IPI can setup switchport access on the switch with the correct vlan this will only work on one interface. The two interfaces are up but the traffic will only go...
HiI have had a number of switches come up with a "Smart Install Remote Code Execution Vulnerability" The solutionI have read on this from Cisco is to apply "No vStack" command in global configuration. however I am worried this will break the stack co...
HiI am looking to make some changes on a nexus core switch tomorrow I have 145.155.130.0 subnet mask 255.255.254.0 I am moving them over to subnet mask 255.255.255.0 and splitting themI am just checking I can use this config on the core nexus switch ...
I am currently looking for a second hand 8 port managed switch to put on the second firewall I only have one currently soon as I get the second switch. I will add it bit of a hunt can't find much under £150 pounds at the moment will see if I can get ...
I have completely changed the configuration and started from scratch ASA Version 8.2(1)!hostname FW1-Site1enable password 2KFQnbNIdI.2KYOU encryptedpasswd 2KFQnbNIdI.2KYOU encryptednames!interface Vlan1nameif insidesecurity-level 50ip address 10.1.1....
I scrubbed the configuration completely and started from scratch going through it line by line I did find the interest bit in it FW1-Site1(config)# crypto isakmp enable outFW1-Site1(config)# crypto isakmp enable outsideFW1-Site1(config)# crypto isakm...
Yeah thank you for stopping that I have made some many changes I didn't catch it working on that all of yesterday I am now going to work through this all day today
