Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
5x Cisco 3750E-48TDFirmware 15.0.2 Hello,i have on my stack a cpu utilization from 65% constant.Actually i have the master (15) on switch1 there also have the 10g uplinks running.Is it possible to move the master to an other member without any reboot...
cisco-sg350-28firmware: 2.1.0.60five seconds: 100%; one minute: 100%; five minutes: 100Input Rate to CPU is 5 pps Hello,we have permanent 100 percent cpu usage on the switch. Is there a way to see which process it is? On our Cisco 3750 there can i se...
Hi,we use a Cisco 800 router to connect our branch office with the HQ.The internet connection is over an isp router established. On the cisco router we have two Vlan Interfaces VL1 with 192.168.1.1/24 there are all clients inside.The VL2 with 10.10.1...
HI BB, correct the VL2 means VLAN2. On the interfaces like FE1 is VLAN1 and on FE2 VLAN2 that is the transfer network 10.10.1.0/24 with the isp modem 10.10.1.2 inside. I can ping 10.10.1.1 but not the 10.10.1.2 isp modem. Here the config: ip source-r...
