Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys, I just wanted to ask a quick question regarding the best way to go about remotely upgrading Cisco stacked switches. Would it be the case that each flash drive would need the new IOS added to it – Then once we are ready to upgrade, we would n...
Hi guys, If possible, please could I have your assistance. We currently have Access Points which are in flex connect mode and are split across 2 x Wireless controllers (5508) – The APs are in high availability mode and will fail over to the secondary...
Hi Guys, I have a quick question regarding deploying PXE boot into a LAN environment, if you could please advise on whether the below is a recommended solution that would be great: Place the PXE Server on a separate subnet to your user machinesConfig...
Hi Balaji,Apologies for the delayed response, Ok great that is reassuring in terms of precautionary measures I am assuming you mean the following:- Checking release notes of the recommended IOS- Having console access to the device- Checking Memory ...
Hi Marce and Balaji, Thank you for the articles this is much appreciated – So it seems that the .tar file is only needed when using a web interface to upgrade the switches and the only difference is having to load the file into each flash memory, as ...
Hi, From doing a sanity check on the controller, the flex connect groups look ok to be honest. The issue is that when the users are looking to connect to the guest URL, they are redirected to the splash page - Once they try to logon to the splash pag...
