Hi,is this setup possible?I have a pc and I would like to connect to remote lan.PC (using vpn client) ---------vpn(internet)-------> ROUTER1 ----------site to site vpn(MPLS network)-----------> ROUTER2 ----------> SERVERHow can I connect to remote se...
Hi all,I have a question regarding VPN (lan-to-lan).My setup is following:10.1.20.x------[PIX515e_central site VPN concetrator]---------(( ISP ))---------[LINKSYS router BEFSX41]----------[Cisco1712_branch]-------192.168.14.xI would like to create VP...
Hi,I would like LMS to send event emails containing sysname instead of IP address of devices. Where can I change that?Also I would like to see devices listed as sysnames and not IPs. (Please check below 2 screenshot I am sending!)I would like to have...
Hi!Can anyone assist me with configuring IPM?(describe in few steps how to set things up)I have a ring network (running OSPF) and I would like to monitor delay and availability on optical lines connecting these devices. I would also like to monitor ...
Hi,I have a problem when arhchiving configurations from my campus devices (routers/switches/firewalls) using LMS.I am keep getting this error messages (for all devices):1. 172.27.1.1 PRIMARY STARTUP Nov 22 2007 12:30:05 ...
Hey.Good news! I was able to connect to router2 today. I placed that subnet (from my vpn client) to the router2 access list for vpn tunnel and I also put my subnet to NO_NAT access list and I have the connection to server now!! Connection trough 2 VP...
Thanks for replying.So I should put subnet 192.168.133.0/24 under configuration for vpn client (under VNC_acl access list):crypto isakmp client configuration group VNC_dostop key xxxxx dns xxxxx domain xxxx.xx pool VNC_pool2 acl VNC_aclVNC_pool2 has ...
Got it working now!! :-)I forgot to ping to remote server from VLAN1 interface to initiate tunnel. Tunnel is now up and running.Only one more question - why are there 2 same tunnels?ta_lj_pdc#show crypto isakmp sadst src state...
I am trying to ping 10.1.20.12. This is the web server behind pix. I tried to connect to port 80 via browser.I will share those files as soon as I get them./editAlso, I cannot ping from router behind PIX, because I do not have access.
