hey, thats why i started this thread. the problem is, that the commands in the other topic are not available switch: load_helper Unknown cmd: load_helper switch: set BYPASS_STARTUP_CONFIG=1 Can't set variable with illegal char "=" (0x3d) in name.
... View more
Hello, like in the topic written, i cannot reset the switch, because of the read only mode of the flash:/ i havent found any solution that worked for me. can anyone help me? switch: dir List of filesystems currently registered: xmodem: (read-only) null: (read-write) bs: (read-only) flash: (read-only) tftp: (read-write) These commands a possible: switch: ? ? -- Present list of available commands arp -- Show arp table or arp-resolve an address boot -- Load and boot an executable image cat -- Concatenate (type) file(s) copy -- Copy a file delete -- Delete file(s) dir -- List files in directories emergency-install -- Initiate Disaster Recovery flash_init -- Initialize filesystem(s) format -- Format a filesystem fsck -- Check filesystem consistency help -- Present list of available commands mgmt_init -- initialize management port mkdir -- Create dir(s) more -- Concatenate (display) file(s) ping -- Send ICMP ECHO_REQUEST packets to a network host readrtc -- Read RTC rename -- Rename a file reset -- Reset the system rmdir -- Delete empty dir(s) set -- Set or display environment variables set_bs -- Set attributes on a boot sector filesystem set_param -- Set system parameters in flash type -- Concatenate (type) file(s) unset -- Unset one or more environment variables version -- Display boot loader version writertc -- Write RTC Thanks for your help
... View more