Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I cant find a quick answer on this one, but if I deploy OTV in a dual L3 DataCentre deployment, does the return traffic follow the OTV path, or take it's own Routing table next-hop...? I need to extend L2 as an interim measure, prior to applicatio...
Hi,I have migrated from a VPN3000 to an ASA running 8.0(4). While it works fine for 1200+ users, around 30 users are unable to connect. Once authenticated the VPN drops.The syslogs are recording the following;%ASA-3-713048...Error processing payload:...
Has anybody figured out, or found an accurate document, on how to configure the interface Firewall ACL's on an ASA which is accepting VPN tunnels.I'm still not certain whether there is a need to permit IPSec, etc. against the external i/f incoming AC...
Hi,Im looking at adding a Resilient IPTV source to our network, which will use the same Source/Group entries as the primary Source, in the anticipation of users failing over to this in event of primary source failure.Obviously under normal circumstan...
Hi,Im looking to deploy IOS IP SLA. I want to use UDP Jitter mode of operation, with its advanced features, to provide sub-millisecond accuracy of results,etc. So will be configuring remote routers as Responders.However, Im now informed that I need a...
Thanks for the reply. I dont think that it does answer my question, however I have now read an article on OTV with LISP which I believe answers it entirely...I now need to find out if LISP is supported in current NX-OS.Thanks, Carl
Thanks Guys...However, I have configured ACLs on the ASA, incoming on the external interface, for other reasons. As there is an Implicit deny any attached to it, is it therefore required in this case? Or does the VPN Tunnel configuration over-ride th...
Luis, what debug did you run, if I run a debug http, I dont get any output relating to this connection attempt...?Also, FYI, I have downgraded back to ver8.0(2) as I never noticed this problem when using that code, I am currently running 8.0(3), but ...
Hi,I have the same issue running 8.0(3) on an ASA5520, oddly enough, it works following a device reload, for a limited amount of time, and I also have oher ASAs with the exact same OS/management configuration, which I can access via ASDM fine.Based u...
Hi mate, Unfortunately I dont know the answer to your query, but am desperately trying to find out...I have some un-explained VPN behaviour, which I'm attributing the the ACLs currently, but the ACLs on the outside interface are not allowing IPSec, y...
