Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,In the following points :-1 - A VRF "CUSTOMER1" assigned to multiple L2VNIs from (10001-1000N).2 - The L2VNI are mapped to the same VRF "CUSTOMER1"3 - Then VRF "CUSTOMER1" would be mapped to a single L3VNI, let say 30000.For L3VNI I have local ...
Hi,I see from Cisco the prerequisites for CCNP data center is valid Cisco CCNA Data center certification or any Cisco CCIE certification can act as a prerequisite, my question is CCIE certification written is enough or should pass also the lab.
I read in book (MPLS fundamentals) in section (Packet Forwarding in an MPLS VPN Network):- How does the egress PE router know which VRF the packet belongs to? This information is not in the IP header, and it cannot be derived from the IGP label, beca...
Hi,Why need the Cisco Catalyst Switches 3560 in CCIE R&S Lab exam, is not Cisco Catalyst Switches 3550 enough? What kind of commands that support by 3560 and not supported by 3550.
For scenario 1 find routing table with my config router bgp 5001 no synchronization bgp log-neighbor-changes network 172.16.1.0 neighbor 192.168.1.2 remote-as 5002 auto-summary R1# sh ip router Codes: C - connected, S - static, R - RIP, M - mobile, ...
