Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I'm wondering if anyone has ever had any luck getting Nest thermostats to stay connected on a cisco wireless network. We are running 5508s (ver 7.2.110.0) and the thermostats are connecting to a 3502. The WLAN is a locally switched FlexCon...
Well I hope this saves someone else some time.If you're able to establish a L2L ipsec tunnel, but lose about 50% of your pings, turn off ip cef! that's probably on the first page of "vpns for beginners", but i didn't find any references to it here. ...
Well this is really helpful. Something must have cahgned recently as this wasn't a problem unitl we upgraded our WCS code from 6.x to 7.x. I did run into problems on step 2. The CLI kept giving me an error so I added the macfilter via the GUI unde...
Additional note.I had to download ftp://ftp.logitech.com/pub/techsupport/quickcam/qc1051enu_x64.exe, which is an older version of the drivers, and complete the same steps in the PRO364 folder (as opposed to PRO464).
I have RME 4.0.6. I did not want to open a TAC case and had seen things about increasing the SNMP timeout. I went into RME and edited the device attributes for the devices I was having problems with. 10 second timeout still failed, but a 30 timeou...
I tried getting dd-wrt/openwrt to work as a bridge and never had much luck. I had mixed results with a linksys retail bridge.Since the code update for WGB functionality has been released, i've had great success with an autonomous 1131 AP in WGB mode...
