Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The traffic flow is the following I have 2 servers (X.X.X.X) to destination to this url's:http://windowsupdate.microsoft.comhttp://*.windowsupdate.microsoft.comhttps://*.windowsupdate.microsoft.comhttp://*.update.microsoft.comhttps://*.update.microso...
How to configure in the new C9800-L controller several VLANS (to segment traffic by office zones) on the same SSID (employee wifi) ? Is it possible? Kind regards.
Users who connect to my company's anyconnect, delete the entire profile / configuration of the client anyconnect,Is there no way they don't overlap and both profiles can coexist (both my company's and my client's anyconnect)? Kind regards.
In a recent auditory, the cibersecurity department found this vulnerability: The remote NTP server responds to mode 6 queries. Devices that respondto these queries have the potential to be used in NTP amplificationattacks. An unauthenticated. remote ...
Hi everybody;I have the following question, i just installed and configured WLC controller with 7 AP's, the management interface have the ip address 192.168.10.90. i am able to ping the interface vlan 10 (internally is the management vlan) of switch ...
Good morning; You mean something like the attached file?? I had configured like that, but it's constantly overlapping the other profile of anyconnect...
Hi!1 - I didn't see any ping arriving to the radius server.2 - For AP the version is:cisco AIR-AP1815I-E-K9 ARMv7 Processor rev 5 (v7l) with 1015824/658320K bytes of memory.Processor board ID FGL2325B2F5AP Running Image : 8.8.125.0Primary Boot Image ...
