Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 1 fiber connection in a port-channel for the 8540 Wireless Controller that consistently shows Received Packets with MAC Errors, FCS errors. Only on 1 port out of the port-channel. Before i start swapping out fiber cable or SPFs on the WLC or...
Is there a GIT repository or place where Provisioning template examples are stored or shared.. Example, trying to create all templates needed to provision a 3850 switch stack in order...all blocks or config.. etc.
After powering up a WS-C3750-48PS switch, Normal POST LED flashing of lights does not happen, instead the switch is stuck in SYST Mode on the front panel. My attempt to hold down the mode button upon powering up for 15 sec fails to reboot the switch....
How do I disable the USB port in the 881 router? 881router#show usb portPort Number: 0Status: DisabledConnection State: DisconnectedSpeed: FullPower State: ON
Sometimes when I do a "show gatek calls" to view current Video calls, the information show for a particular call shows the H323ID calling itself, however it shows different E.164 address for SRV and DST endpoint. This does not look right to me. Calls...
Yeah i suppose it could be, but I'm running 8.5.135.0 on other controllers as well and all ports are clean on those.
just this one WLC on one port from a 6500 series. FCS errors from what i understand can be caused by possible bad or dirty fiber jum...
This is the output of "sh int counters" on the ten Gig interface on the 6500 side.
64 bit counters: 0. rxHCTotalPkts = 88541569180 1. txHCTotalPkts = 69256567692 2. rxHCUnicastPkts = 8852...
Does this version work with 5760 running IOS-XE 3.6.6E ??
Would like to give software a try. Still required to use Sh run-config?
The 5760s running 3.6.6E are still using show running-config.
Thanks,
Jeff
