Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have created IPsec tunnel phase1 ,2 as below but tunnel is not up consider the below :source 172.16.16.0/24 and dist 172.30.55.0/24configuration on router Acrypto isakmp policy 10encr aes 256hash sha384authentication pre-sharegroup 14lifetime 28800...
i have switch 2960-X with version 15.0 have updated to 15.2 but after update to newer version , uplink was down and shows me cisco error msg then i have tried to get back to old version but it keeps reloading to the updated version , after many times...
i am using any connect vpn for cisco and it shows mr erre that failed to get configuration from secure gateway , i have check anyconnect connections profiles and make sure that profile is created with group policy (GroupPolicy_AnyConnect-VPN ) with A...
i have exist routing in switch through internet line ip route 0.0.0.0 0.0.0.0 192.168.53.2 ip route 10.223.0.0 255.255.0.0 10.X.X.X ip route 10.245.0.0 255.255.0.0 10.X.X.X ip route 10.250.0.0 255.255.0.0 10.X.X.Xip route 172.18.0.0 255.255.0.0 10.X....
Hi ,i have applied the commands after review the guide again as the below but still tunnel down :access-list 100 permit ip 172.16.16.0 0.0.0.255 172.30.55.0 0.0.0.255crypto isakmp policy 10encr aes 256hash sha384authentication pre-sharegroup 14lifeti...
i have performed the steps for Configure a LAN-to-LAN IPsec Tunnel Between Two Routers - Cisco but tunnel is not up ,also what do yon mean peer IP in same subnet as remote LAN ? remote peer address is 172.30.55.10 (destination )and local subnet is ...
yes i have created access list (access-list 100 permit ip 172.16.16.0 0.0.0.255 172.30.55.0 0.0.0.255)and under outside interface i have applied the cryptointerface FastEthernet0switchport trunk native vlan 3665switchport mode trunkno ip addresscrypt...
