About gowdakssujan

gowdakssujan · 11-25-2019

Could you please provide the revised ccnp syllabus...

gowdakssujan · 11-12-2019

do portfast disables stp?

gowdakssujan · 11-11-2019

How do switches learn dynamic mac addresses?Say S1 is connected to S2(fa0/1-fa0/1)Where do '0001.630...

gowdakssujan · 11-06-2019

what is the difference between #terminal monitor & (config)#logging monitor commands

gowdakssujan · 10-28-2019

Does any of the L3 switches support serial interface ???

gowdakssujan · 10-28-2019

Does cisco 1841 support WAN??

gowdakssujan · 10-28-2019

What is the difference between 'boot' and 'reset' command in rommon mode????

gowdakssujan · 10-26-2019

How does mini-IOS helps in boot process??How/why do router enter/load into mini-IOS??

gowdakssujan · 10-18-2019

(config-if)#switchport trunk pruning vlan 3-4 If the trunk port receives broadcast for vlan 3 or 4 a...

gowdakssujan · 10-18-2019

where will VTP client switch saves received information from VTP server?

gowdakssujan · 09-24-2019

r2(config)#username r1 password ciscor2(config)#int s0/3/0r2(config-if)#en pppr2(config-if)#ppp au p...

gowdakssujan · 09-24-2019

r1#sh run | in userusername r2 password 0 ar1#r1#sh run | in pppencapsulation pppppp authentication ...

gowdakssujan · 09-13-2019

How many standby routers an HSRP standby group can have?

gowdakssujan · 09-13-2019

Does the uptime of the router matters while electing the active router?

gowdakssujan · 09-12-2019

What is difference between hold timer, active timer and standby timer? They're all purposes same

ccnp R&S