Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Having an issue where the spoke and reach the hub and vice versa. But NHRP can't register and create a session. Any ideas? dmvpn-hub-csr1#show run int Tu1Building configuration...Current configuration : 386 bytes!interface Tunnel1bandwidth 1000000ip ...
I'm having an issue with auto-replacing a config archived on bootflash. The error it gives me isn't very informational on the issue so I'm not really sure how to troubleshoot. replace-me#show archiveThe maximum archive configurations allowed is 5.The...
Hello, I'm trying to configure IPsec tunnel using crypto maps. I can't get the crypto session to associate. Some of what I'm reading is relating to a bad ACL config but it doesn't appear to be the case here, maybe. Error in the logs, I can't find muc...
I'm simply trying to access adsm and when doing show log I see that the traffic is getting block by an ACL. %ASA-3-710003: TCP access denied by ACL from 192.168.1.84/1092 to g0:192.168.1.180/443 %ASA-7-710005: TCP request discarded from 192.168.1.84/...
It can't be as its another router. dmvpn-hub-csr1#show ip int briefInterface IP-Address OK? Method Status ProtocolGigabitEthernet1 10.12.1.2 YES NVRAM up upGigabitEthernet2 unassigned YES NVRAM administratively down downGigabitEthernet3 unassigned Y...
dmvpn-spoke-2#config tEnter configuration commands, one per line. End with CNTL/Z.dmvpn-spoke-2(config)#logging consoledmvpn-spoke-2(config)#exitdmvpn-spoke-2#*Jul 24 02:29:39.674: %SYS-5-CONFIG_I: Configured from console by consoledmvpn-spoke-2#dmvp...
dmvpn-hub-csr1#show ip int briefInterface IP-Address OK? Method Status ProtocolGigabitEthernet1 10.12.1.2 YES NVRAM up upGigabitEthernet2 unassigned YES NVRAM administratively down downGigabitEthernet3 unassigned YES NVRAM administratively down downG...
