Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Morning all!I have some switches that we tested in StackWise configuration, now they have some interface sets at g1/0/x and some at g2/0/x. I'd like to standardize them all at g1/0/x, and eliminate references to "Switch 2" so that everything not Stac...
Morning all!We're looking to add some redundancy for a few of our larger hosts and I'd like to trunk two ports for one of our devices. The question is, if I have a StackWise connected pair of 3750's, can I trunk one port in Switch A with one port in ...
Anyone seen an issue where doing a "show run" pegs the CPU on a switch that's in StackWise? We have a 6x 3750 stack running 12.2(55)SE and when we do show run the CPU goes to 95% or higher. Often SSH will be at 50-70% of the CPU. A 2x 3750 stack runn...
Correct, the switches are no longer stacked. I needed to test their stackwise ports before putting them on the production floor and they have the configuration from that test. I'd like to put all the non-stacked switches as g1/0/X so we can automate ...
Wen, thanks!Is there an expected time SHA-2 will get to the 12.2 line? I can't see the "partner" website you sent, we're only on a customer support level.Leam
How do I tell? Is there an IOS command to show? Can it be configured? If there's an option for SHA-1 or SHA-256, how do I make sure I'm only using the latter.Thanks!Leam
We are having a similar issue on a 3750 stack. Oddly, after looking at the queues and turning off console logging, things seem to have quieted down. This is not a "cosmetic bug", as far as I can tell; we were having throughput and backup failure erro...
