Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm not getting connected state always in event OnCallStateEvent on tapiIn our existing application with aashtra switch, when I deflect the call from CTI port to any extension it get accepted and answered automatically it's implemented in that way, h...
I have Implemented tapi api in dotnet 2010 using C# and for this have used tapi wrapper 1.4.0 and switch/devices configuration is done on cucm 10.5In my application, we have subscribed below two events of tapilineCallStateChanged and CallInfoChanged...
My system is on windows 7 64 bit opearting system, and have used atapi dll in my dot net application to implement atapi api.I have used ATAPI Wrapper of vesrion 1.4.0 will it create any issue?Or should I use atapi 64 bit? If yes then What would be...
In our application, we have integrated Cisco switch and for telephony call control have implemented atapi api.I'm not sure why sequence of callstate is not constant under event 'OnCallStateChanged' When make consultation call to number which is in bu...
In our application, we have integrated Cisco switch and for telephony call control have implemented atapi api.When any conference member get disconnected from conference call then event OnCallStateChanged get raised for callstate.idle for all confere...
When CTI route point was in registered state then also it had same issue.
Is there any cucm configuration issue in shared screenshot of DN and CTI route point ?
Hi Deepak,
Thanks for the information, it works with different CTI route point.
My concern is if we can add multiple DN's number, then it should allow to monitor multiple DN's numbers in CTI Route point.
