Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There isn’t really enough in your message to point to the root cause, but I can suggest some things to look at. First, let’s understand what “offline” means. After a WAE registers with the CM, it is configured to check back with the CM every 5 minut...
On the router/switch run 'show ip wccp 61- detail' will list all the WCCP clients and the buckets they own. On each WAE (WCCP client) you can run 'show ip wccp flow tcp-promiscuous detail' (adding 'detail' will give you a little more information for ...
The best practice depends on your network. Most deployments are fine with the default round robin configuration for port channel on the WAE. But I have encountered some installations where the configuration had to be changed in order to avoid out of ...
You probably encountered CSCtj49204. Please go to the CM GUI -> My WAN -> Configure -> System Properties and set cdm.remoteuser.deletionDaysLimit to 1. Wait 24 hours after making that change and try again.Sent from Cisco Technical Support iPhone App
The amount of traffic reduction you will realize in any given direction will depend on many factors, such as, but not limited to:- the amount of traffic traversing the WAN in that direction. You are more likely to see greater savings in the direction...
