Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a Cisco WLC 2504 ver. 7.4.110 with LWAPs connecting from various global locations through Flexconnect. I would like to know if we can configure access to network resources based on the devices type like Mobile, laptop and Desktop. Is it...
Hello All, I am trying to configure Posture validation on my Cisco ASA with Anyconnect. I have uploaded the host scan image and the CSD image on the firewall and enabled both.After i configure a Dynamic Access Policy (DAP) for checking if the system ...
Hello,I have a 3925 router Version 15.2(4)M5 which is being used for terminating a back up Internet link and will be used to SSh the internal devices from outside in cas eht e primary link fails.All the internal devices are reachable from the router ...
Hello,I have configured ACS 5.4 for AD authentication from WLC and configured the ACS serveras accounting server in the WLC but when i go to Monitoring and Reports --> Catalog --> AAA Protocol --> RADIUS_Accounting, i get the attached error. Also i ...
Hello,I have a Cisco 2500 series WLC with SW ver. 7.4.110.0. there are more that 10 LWAPPs registered in it.I want to move them to an old WLC runing SW ver 7.0.240.0. I need to do this because we purchased some new 2600 series LWAPPs that are support...
Hello VB, Thank you very much for the solution. One more query is that can we get a list of device types from the controller, which devices e.g. Android or Windows or Apple are connecting to the network. If we get this list then it will be easier to ...
Thanks Scott, Is there a way we can get Layer 3 roaming between subnets by adding or upgrading the LWAPs or the WLC. Is there a way for achieving this? Thanks again for the extended support. Regards,Anand.
Thanks Scott, Please share any document if available so that i can present it to my management to support this issue with flexconnect. Thanks again, Anand
Hi, Please let me know if we have a single controller Cisco WLC 2504 and 2 different VLANs configured for same SSID, will the clients be able to roam between the floors (which are separate VLANs).It is on if they do not retain their original IP addre...
Hi Ankur, The link specified is not opening.Please let me know if we have a single controller Cisco WLC 2504 and 2 different VLANs configured for same SSID, will the clients be able to roam between the floors (which are separate VLANs).It is on if th...
