Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Very strange thing happens after we upgrade the two 5K to 7.1.4.N1.1 from 7.1.1.N1.1. The symptom is below:
copy running-config ftp://admin@10.2.2.2//tftpboot/conf/5k-1-config-11132018
Enter vrf (If no input, current vrf 'default' is considered):...
Have tested using DUO with ISE2.3 and ACS 5.6 for network device access using 2FA. Here are the steps for your reference:Setup DUO proxy server and add ISE IPs as DUO proxy clientsIn ISE, add DUO as a RADIUS Token in Administration > Identity Manage...
Hi,I have just installed the secondary ISE and did the followings, but when I try to join the primary node, I received the Cannot authenticate the primary ISE, please check the server or certificate and try again.- promote the secondary from standalo...
I plan to upgrade Virtual FMC from 7.0 to 7.2 and downloaded the file: Cisco_Secure_FW_Mgmt_Center_Virtual_VMware-7.2.4-169.tar.gz to local drive and then try to upload it to FMC, I got the same error: ErrorUpload failed: Update is not a signed packa...
Thanks Richard:It can be L2 and L3 mixed in a special situation like I mentioned. I gotCisco confirmed that using mode on on both ends works.Regards,Song
Any suggestions between L2 and L3 port channel configurations? typical example is for internet connection redundancy setup; Two Internet IP routers and each have L3 channel group configured connecting to a L2 stack switch. The L2 stack switch will...
Thanks, Marvin:
I have just upgrade my ASA to the latest interim release 9.10.1.7 and AnyConnect client 4.7.00136. It comes up with DTLSv1.2 and it can be seen in both ASA and Client GUI interface:
DTLS-Tunnel: Tunnel ID : 8.3 Assigned IP : 192.16...
