Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, just have a question about som reuse of resources in a ACE module context. I don't want to make a new context, and can reuse most of the existing configuration in one of my context. The config is not complex and difficult, but I'm not sure ...
I have 2 Nexus 5000 and they will be used along with HP22BP. We ordered the FET-10G, and it seems to work with the HP22BP.But we forgot to order SFP+ 10G SR module. While waiting for these modules, and to continue the configuration, I understand th...
Just recently installed CW LMS 4.1. In the Configuration Dashboard you can see Discrepancies and Best Prctice Deviation. In our old 4.0 it shows a list of both discrancies and bestpracice deviation. In our new 4.1 we only see "No data is available...
Hi.I have 2 3750 running IOS 12.2(35)SE5. Today I lost power to one switch in one of the stacks.Since I've configured etherchannel, it should work fine. But it didn't. The switch in the opposite end, reported interface Gi1/0/1, Gi2/0/1 and Po1 down...
Hi,I'm having problem with the HSRP standby VIP address configured on Vlan699 between a 6509 switch and FWSM (in slot 8 in the same 6509).If I connect a pc in Vlan699, I can ping 6509 Vlan699 SVI ip address, and also the HSRP standby VIP address. Th...
Thanks for your reply.Hope I understand you correct. This sould be the config I need to paste into the existing context.rserver host cwi503 description content server logon 2 ip address 10.163.22.23 inservicerserver host cwi504 description conte...
Ok, I found the problem. I run FWSM in multiple context's. System, Admin and one security context. I've been working with the security context, not figuring out why it didn't work. The Admin context works, since I've been using it for upgrading t...
