Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are trying to setup the virtual APN with "pre-authentication" feature on GGSN Release 9, whereas the Radius server changes the APN during the authentication stage.The question is which Radius attribute in the Access-Accept should contain the new A...
We are trying to setup the virtual APN with "pre-authentication" feature on GGSN Release 9, whereas the Radius server changes the APN during the authentication stage.The question is which Radius attribute in the Access-Accept should contain the new A...
I am trying to provide a captive portal with the support of some Cisco box.The requirements are:- "Unauthorized" source IP addresses on certain interfaces are redirected to an external node.- There is an interface to change the status of an IP addres...
Suppose that the AP and Controller communicate over a L3 network.Can NAT be performed in between?For example, suppose that the AP is connected to an ADSL router that performs NAT.
Please I need help from someone who has ever wondered and get to know the maximum number of simultaneous IP sessions on 7600. On the documentation, this is the applicable information that we find regarding the number of sessions:http://www9.cisco.com...
Thanks for the suggestion.In my case, user experience is essential, we definately need to show a customized login page hosted in an external node.Without hands-on knowledge on Cisco ASA, trying to be creative, I wonder if the following is possible:1)...
Thanks indeed for your response.In fact I could not obtain any support at all from Cisco (Spain) even if I explained we were a small software company that required ISG to complement an existing solution for a BIG mobile operator. The question was sup...
Thanks Terry.And please let me know if my interpretation is correct:- Suppose that I specify a Timeout (attr 27) in the Radius Access-Accept , together with Termination-Action (attr 29) set to "Radius request".- After Timeout elapses, the Controller ...
