Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear team, One of the Customer is asking for the following test scenario for NRFUThe customer wants to unplug the power Cables from all three APIC nodes instead of graceful Shutdown at each site and wants to check if it works fine aft...
Dear Cisco team, One of Customer is asking for following test scenario for NRFUThe customer wants to unplug the power Cables from all three APIC nodes instead of graceful Shutdown at each site and wants to check if it works fine after ...
Dears, i have one question regarding native vlan. i have two switch as below :SW1inter f0/1swicht port mode trunkswitch port trunk allow vlan 5-20switch port trunk native vlan 10 SW2inter f0/1swicht port mode trunkswitch port trunk allow vlan 5-20swi...
Dear Community Support,i have on question about APIC-EM ACL. Analysis tool.which two values are needed to run the APIC-EM ACL Analysis tool?is it destination address and source address.
what if i got question like below:which two values are needed to run the APIC-EM ACL Analysis tool?1. destination ip address.2. destination port3. source ip address4. source port5. protocolwhat is the best choice would be ( only two choose)
