Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We use Cisco Prime 1.4 (1.4.0.45) and have the problem that the devices are in the stated " Managed with warnings" .The SNMP and telnet parameters are correct and when I discover the device it is managed but after a few days the state will be `...
I have a ASA 5520 with version 8.2.1 and asdm 6.2.1, when I connect the ASDM over the network from my workstation everything works fine, but when I setup a ssh tunnel from another workstation to my workstation and tunnel the https traffic, then is no...
When we connect to our ASA with anyconnect, windows 7 throws: "The vpn client was unable to setup ip filtering. A VPN connection will not be established". On a Mac it works perfect. We tried this on several windows 7 systems, but no luck.Any help wel...
What issues can arise when you configure different MTU sizes on a metro ethernet link?I have some doubts, but our development department says that it shouldn't be a problem. What do you think is best practice.Cheers, Marco
Can anyone explain the interface reliability counter. I know that 255/255 means a 100% reliable interface during a 5 minute average. But what event(s) triggers the reliability counter to change.Kind regards,Marco
Can you post a "show ip route" from both routers?When you can't see any rip entry's post a "debug ip rip" as well.What is the default gateway configured on node 10.2.1.76 and on nodes 10.3.x.x?
First of all, your "Router Option" should be 10.3.0.254 for clients on the remote site, as this will be there default gateway.On Router B you have a static route 10.0.0.0/8 through 10.2.0.0, this route should be deleted! I would suggest you use Rip V...
Hi GP,Thanks for your reply, but the issue is that on an interface DHCP is used, so i don't know what address will be used there. I believe OSPF and EIGRP doesn't run on interfaces not configured with the network statement. An other issue is that i c...
