About Hassaan

Hassaan · 06-03-2022

Hello everyone, Am hoping someone has any idea or know of a situation where the routing table updates as expected, i.e. shows the correct route, but the forwarding table does not point to the correct next hop/outgoing interface in the cef table? I kn...

Hassaan · 04-19-2022

Hi all, I'm looking for advice on how to configure a network with more than one route reflectors. My specific scenario is that I wish to redistribute an ebgp route into our AS and within this AS I wish to create ibgp route reflectors to "reflect" tha...

Hassaan · 02-28-2022

Hi,I have two ISE VMs and am thinking of deploying them as a "split deployment". Which as per my understanding places the two nodes in an Active/Active HA pair. So basically I want PAN, PSN and MnT personas to be running on both nodes and should one...

Hassaan · 12-19-2021

Hi all, I am a little lost in the myriads of documentation on cisco website. Basically I am coming from Juniper world and need to create a routing policy that permits static, directly connected routes etc. over ibgp/ebgp. This is an example of wh...

Hassaan · 12-27-2020

Hi all, I've reached a point where i need some help with this as i've been trying to figure this out for some time now and starting to get frustrating.DNA-C is all new to me and i've learned a lot about it over the past few months but now i want to s...

Hassaan · 06-04-2022

@Harold Ritter Thanks, i ran those commands and that gave me the clue as to what the issue was. It turns out the 194.82.96.0 route was being exported over OSPF from a router along the backup path. All i needed to do was create an export policy for th...

Hassaan · 04-21-2022

Thanks @paul driver , I did try a both your suggestions at the beginning and it didn't work. Just tried it again to be sure and still didn't work. If the only way to get around this problem is to use @MHM Cisco World solution, enhanced with a backup ...

Hassaan · 04-21-2022

Below is my topology and I've attached the running config of the two RRs. Let me know if you would like me to add the client router configs. @Flavio Miranda I applied that command on the two RR routers and it didn't seem to have any effect. It didn't...

Hassaan · 12-21-2021

Thanks again @Harold Ritter That looks like it answers my question, just what i was looking for.I do have one last question though. We have two Internet connections and would like to configure the routers to back each other up by redistributing their...

Hassaan · 12-20-2021

Thanks @Harold Ritter Ok so further to that what if i wanted to, for example, accept or deny certain subnets from being advertised over a certain routing protocol?

Member Since	‎11-08-2019 04:39 AM
Date Last Visited	‎04-21-2023 12:06 AM
Posts	21
Total Helpful Votes Received	41

User Statistics

User Activity

CEF forwarding table not updating

Multiple BGP route reflectors question

ISE split deployment question

routing policy options question

Trouble with dnac Plug and Play/claiming a device

Re: CEF forwarding table not updating

Re: Multiple BGP route reflectors question

Re: Multiple BGP route reflectors question

Re: routing policy options question

Re: routing policy options question