Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a MX84 that the WAN port is coming up as 100/half. I dont have access to the WAN config from the providers equipment. I'm looking for somewhere to change or modify the port settings for the WAN ports but cant find anything. Can someone share...
Is there any way to get a temperature reading from within the access point? I need to install access points on a large scale across a campus and they are going to be inside of a nema enclosure and out in the direct sun most likely. I have one that ...
I have a Linksys wrt54g that has the dd-wrt firmware loaded on it. I have a site in Florida that has DSL that wants to connect via VPN into their corporate network in South Carolina. Does anyone know how to go about configuring that Linksys to do a...
I see no "ethernet" option on the Appliance status page of the MX84. Where is this located? Under the Uplink tab there is no where I find to set the speed or duplex of the port. Only to set the IP info.
No. I have no way of opening a TAC case since the 2504 is out of warranty and I dont have smart-net on it. this is just a lab controller that i used for testing. I would love to be able to get it back up and running but at this point I'm stuck. I...
I too have this same issue. My main problem is that my wlc is not under a contract and its a lab wlc. I cant open a tac case on it. Is there anyway you could provide the RTOS for 2504? Im kinda stuck here with a dead box.
Thanks!
what i ended up doing is just adding both lines to the same SNR profile and it worked great. The end user could turn them on and off at will depending on which site they were at.
