Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have three interfaces configured, outside, inside and dhcp. The IP for the inside is 10.10.220.101 and dhcp is 10.10.230.1, with same−security−traffic permit intra−interface configured but still not able to communicate between interfaces. The err...
I have configured our ASA with an interface for the internal network (BeneNetwork) and our wireless solution (WLAN) everything is working OK the wireless clients receive all configurations from DHCP and can ping the the gateway address., but does not...
There was two issues I had to add nat statements, also I was connecting through the same switch thus creating a loop.Added nat statements and segmented networks and all works great! Thank you to everyone who responded.Stephen
I am still getting the following, also I cannot ping from a node on the 10.10.220.0 network to 10.10.200.1 which is the interface on the asa.packet-tracer input inside icmp 10.10.220.101 8 0 10.10.200.1 de$Phase: 1Type: FLOW-LOOKUPSubtype:Result: ALL...
ok i completed the task i am permitting all ip traffic both ways without success, oddly enough from the workstation i cannot ping the gateway which is the landhcp interface. from the console i can ping the landhcp but not past this.
