Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have searched the knowledge base to try to understand if this was something already answered.
Unfortunately, I cannot find a suitable answer.
I have WLC5508 with soft version 8.0.115.0 and some mobile phones cannot connect. Most of them are A...
Hi Neven,
It seems they are talking about:
http://www.cisco.com/c/en/us/support/docs/ip/network-address-translation-nat/4606-8.html
Inside local address—The IP address assigned to a host on the inside network. This is the address configured as a ...
Hi Seaweeds
You should take a look at this post:
https://supportforums.cisco.com/discussion/10972781/eigrp-traps-are-not-generating-router?recent=0
I think it will answer your question. If it doesn't, we can move from there!
Thanks,Ricardo
Hi Neven,
Can you put the command you are trying to use?
Source IP can be used on an access-list to only allow certain IPs or ranges to NAT outside to the outside, for example.
Just write the command and we can go from there!
Thanks,Ricardo
Hi,
Did you put the tacacs-server command as well? It should be on the bottom of the show running-config. Something like:
tacacs-server host 10.10.10.1 timeout 5tacacs-server key 7 095C4F1A0A1218000F
The config might change a little (depending on IO...
