Hi All,anyone knows if VRRP is supported in two addresses way with vPC configuration?On Cisco Site i can see VRRP/vPC support but with this configuration (apart subnet errors...)http://www.cisco.com/en/US/docs/switches/datacenter/sw/5_x/nx-os/unicast...
Hi all,how can i replace in 8.3 a NAT identity like:nat (outside) 0 0.0.0.0 0.0.0.0 0 0nat (inside) 0 0.0.0.0 0.0.0.0 0 0and alsoestablished tcp 0 4000 permitto tcp 4000 permitfrom tcp 1024-65535tnx a lot for any answerDan
Hi all,question about PBR:can take precedence on connected route in any way?I've tried putting ACL restrictive than subnet but it seems not to work.I need to route traffic from subnet A to B towards a FW, subnet B is configured both on 6K and on FW. ...
Hi all,i've got two simple questions: 1 resource class allocation, minimum is guaranted, maximun if unlimited means that i can exceed minumium, am i right (ex sticky)? 2 sticky database, release before 3.2.5 (appliance) when command ...
Hi all,few questions about vPC:1 L3 devices attached vPC 7K, is NOT a recommended topology...so what do i have to do if i have to migrate some 6K to 7K with attached a lots of L3 multilayer switch? Just connect them in a non-vPC way? Could be a big m...
Hi Lei,tnx a lot for answer!I was thinking about different VRF but i need (sometimes) traffic intra-vlan. So in VRF fashion with Nexus 7000 release 4.2.X (but i'm pretty sure also in 5.X) route leaking with import-export is not possible yet.maybe i'l...