01-04-2012 12:36 AM - edited 03-07-2019 04:09 AM
Hello
I have configured pbr on 2821. And the next hop on route map is pointing another subnet and not same as the router interface to which route map is applied. should this type of configuration work. ios version is 12.4
I dont see anything on debug ip policy
thanks
01-04-2012 12:50 AM
Hi,
the next-hop must be directly connected otherwise it won't work.
Regards.
Alain
01-04-2012 01:29 AM
Thanks.
The network setup is two routers (on different networks) are directly connected to the same firewall. The return path/route for the source WAN subnet defined on the FWSM is pointing to router B. However, for some destination networks I would like to make FWSM point to router A for the same source WAN subnet. Since FWSM does not support PBR, I have configured PBR on router B. So that when such a traffic reaches router B, the route-map should get trigged and it points to router A (which is on different/directly connected network).
If I were to point it FWSM, it would route back to router B again.
Please suggest.
Thanks.
01-04-2012 01:51 AM
Hi,
could you post a topology diagram because I don't see exactly the design and goal you wish to achieve.
Regards.
Alain
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide